This article involves all safety precautions and procedures to follow before using the LaserPecker LP5 machine.
1. General Safety
- Only use this machine in accordance with these instructions and all applicable local and national laws and regulations.
- Read and get familiar with all safety precautions and procedures before using the machine. Strictly follow all safety precautions. Ensure that the machine is properly assembled and is working properly.
- DO NOT allow use by minors, by untrained personnel, or by any personnel suffering from any physical or mental limitation that might affect their ability to use the machine safely and properly.
- Ensure that the workspace is clean and flat.
- Keep the area around the machine dry, well ventilated, and environmentally controlled to 50 – 95°F (10 – 35°C) and 10 – 95% humidity.
- DO NOT leave the machine unattended during operation.
In the event of the following situations, please stop using the machine and cut off the power immediately:
- A burning smell is detected coming from the machine.
- Open flames or sparks are observed being generated from the engraving material.
- Any components of the machine appear to be damaged or malfunctioning.
- Unexpected cessation of machine operation for no clear reason.
- Abnormal sounds, smoke, or unusual lighting are emitted from the machine.
2. Laser safety
- The LP5 Basic is a Class 4 laser system. When assembled and locked with a safety enclosure, the laser system is Class 1.
- The active laser and its reflections can rapidly cause fires, burns, and permanent vision damage. Under normal circumstances, the laser is blocked by the protective cover or safety enclosure during operation. Before using the machine, ensure that the protective cover or safety enclosure is installed properly. If it cannot fully cover the object, you need to wear safety goggles that can shield your eyes from the laser beams.
- During operation, the materials being engraved or cut may release toxic and harmful gases or fumes. Depending on the type and composition of the engraving/cutting materials, these emissions can pose health and environmental risks. To ensure safe use, it is recommended to use this machine with an air purifier to effectively absorb and filter any toxic or harmful gases and fumes generated.
- DO NOT use this laser in dewy, dusty, or high-EMI conditions where the active laser might easily be deflected or reflected.
3. Electrical Safety
- Only use the machine with stable and compatible power sources. This machine requires a 24V/7.5A power adapter. Failure to use the compatible power adapter can result in machine malfunction.
- Do not allow any electronic component to become wet and always fully disconnect the machine from power before undertaking cleaning, adjustment, maintenance, or repair.
4. Warning Labels
The warning and instruction signs are labeled where physical injuries or damage to the machine may be caused before and/or during operation. If a sign is damaged or lost, replace it immediately. You can use the following template to print the sign you need.