1. Rotary Extension Assembly and Connection
-
Install the Rotary Extension on the main unit according to the user manual. It should look like the picture below when assembled correctly.
-
Connect the cables as shown in the picture.
Note: Should you connect the Electric Stand cable to the Accessory Output Port, you can only elevate or lower the Electric Stand by pressing the buttons manually, instead of via the mobile application.
2. Securing materials with Rotary Extension
-
Press the “Lock Button” (highlighted as part 1 by the red arrow in the diagram) to secure the “Rotary Head chuck”, avoiding rotation.
-
Rotate the “Chuck Gear” (highlighted as part 3 in the diagram) to adjust the grip diameter.
-
Upon securing the material, release the "Lock Button".
How to press the Lock Button: Align the white dot with the white arrow (highlighted as part 2 in the diagram).
Note: Once the material is secured, release the Lock Button to enable rotation of the Rotary Head chuck during preview. Failure to do so will impact subsequent engraving.
3. Activating Rotary Extension in Mobile Application
Please ensure the accessory and main unit are powered on before activating the Rotary Extension for normal use.
If you activate the Rotary Extension in the Setting before powering it on, it will not work normally. Please restart the mobile application and connect the Rotary Extension to the power supply.
-
Successful LP4 Bluetooth connection is indicated by a solid blue light.
Once you power on both the Rotary Extension and main unit, the former’s indicator light will turn blue, confirming its power status.
-
Activate the Rotary Extension in the Setting interface of mobile application. You will then hear two beeps from the machine. Please check the operations in the diagram below.
How to check the normal operation of Rotary Extension:
Rotate the “Rotary Head chuck” with the Lock Button on the Rotary Extension released. If you feel significant resistance, then the Rotary Extension and main unit can work normally.
4. Engraving with Rotary Extension
Creation Interface
Click “Creation” > “Material” on the Home Page of mobile application. Choose the image to be engraved and import it. Drag to adjust its size and shape within the area indicated by the red rectangle.
Before Preview
-
Click “Preview” in the top right corner of the Creation interface.
-
Click “Preview” in Rotary Extension Mode, and input the perimeter or diameter (in mm or inch) of the object.
Tip: Incorrect or void values of diameter/perimeter may cause engraving deformation or overlap.
Please note that millimeter or inch is the unit of length in mobile application. You can click “Settings” in the bottom toolbar of the Creation Interface and swipe left to switch from inch to millimeter.
During Preview
During the preview in Rotary Extension Mode, a straight blue beam will be emitted to the object to be engraved, indicating the image’s X-axis width in the mobile application: X:83.36mm.
The Rotary Head chuck will rotate after clicking “Continue”, and rotation path corresponds to the image’s Y-axis height: Y:79.14mm.
Release the Lock Button before starting previewing. Otherwise, the Rotary Head chuck is unable to rotate. If the Rotary Extension doesn’t work properly, please check if there is any misoperation in step 1 and 3.
Engraving
Set the engraving parameters after previewing the size and position of the image. Start engraving and wait for completion.
Laser Selection Tips:
For wood, paper, bamboo, food, genuine leather, etc., please choose the 450nm laser:
For metals and plastics, please choose the 1064nm laser:
Comments
0 comments
Article is closed for comments.