LaserPecker 3 Blinking Red and Green Troubleshooting

  • Updated

Here is the guide on troubleshooting the LaserPecker 3 Blinking Red and Green.

 

 

I. Preparation:

LP3 laser unit, rubber suction cup*1, thin insulate rubber tape(1mm) *1/scotch tape *1, H3 wrench*1, ruler*1, thin knife*1/ tweezers*1.

Preparation

II. Steps to solve this problem

Disassemble the cover plate of LP3's laser head → Stick the tapes on the rare of the buttons

Check the tutorial video here: http://bit.ly/3IiLfoh

 

Detailed Steps:


1. Use a thin knife/ tweezers to peel off the black paster on the handle. (Please be careful when using a knife.)

step 1-1 step 1-2

2. Unscrew the screw inside the handle with a H3 wrench.

step 2-1 step 2-2 step 2-3

3. Use the suction cup to pull open the cover plate of the laser head, and use a ruler to help

fully open it. (Don't force it open, or else it will bend the plate.)

step 3-1 step 3-2 step 3-3

4. Cut two round tapes out of the thin insulated rubber tape/scotch tape, and stick them to the rare of the two touch buttons.

step 4-1 step 4-2

5. Assemble the cover plate, handle, and black paster as they used to be. Now you've finished all the steps required.

step 5-1 step 5-2

Related to

Was this article helpful?

0 out of 1 found this helpful