Adjusting the Exhaust Duration of LP2 Safeguard

  • Updated

This guide explains how to adjust the Exhaust Duration when using the LaserPecker LP2 with the Standard Enclosure.

Step 1: Open Mode Settings

  1. Connect the LaserPecker LP2 to LDS.
  2. Enter the Create interface.
  3. Click the Settings button in the top-right corner to open the Mode Settings page.

Step 2: Adjust Exhaust Duration

  1. Locate the [Exhaust Duration After Processing] setting.
  2. Adjust the time according to your needs (range: 1s–300s).
  3. This setting controls how long the Standard Enclosure Fan will run after the engraving process to remove smoke.

1.png

Was this article helpful?

0 out of 0 found this helpful