The LaserPecker LX2 is equipped with a Multifunction Button and an Annular Indicator Light.
The indicator provides real-time feedback on the machine’s operating status through different colors and light states. By pressing the button in various states, you can easily perform different functions.
The table below summarizes the indicator color, device status, and the actions triggered by a short press or long press of the button.
| Buzzer | Annular Indicator | Machine Status | Button Operation |
|---|---|---|---|
| / | Blinking White | Standby | / |
| / | Blinking Blue | Network Configured, Not Connected to Software | / |
| / | Solid Blue | Standby, Connected to Software | / |
| / | Blinking White | Auto-Focusing | Long Press to Exit |
| / | Blinking White | Measuring Curved Surface | Long Press to Exit |
| / | Blinking White | Material Positioning | Short Press to Mark; Long Press to Exit |
| / | Solid Purple | Previewing | Long Press to Exit |
| / | Solid Green | Ready to Start | Short Press to Start; Long Press to Cancel |
| Beeps once | Solid Green | Booting | / |
| Beeps once | Blinking White | Configuring Network | Long Press Button for 5s to Enter Network Configuration Mode |
| Beeps once | Breathing RGB | Processing | Short Press to Pause; Long Press to Cancel |
| Beeps once | Blinking Red & Blue | Firmware Upgrading | / |
| Beeps once | Blinking Purple | Processing Paused | Short Press to Resume; Long Press to Stop |
| Beeps once | Blinking Purple | Device Error (Machine Tilted During Engraving) | / |
| Beeps three times | Blinking Red | Firmware Startup Failed | Reboot After Power Off for 3 Seconds |
| Continuous beep | Blinking Yellow | Laser Module Not Properly Connected / Lid Not Fully Closed | / |
| Continuous beep | Blinking Red | Flame Detected | Short Press to Cancel Alarm |