LX2: X-Axis Not Moving or Moving Irregularly

If the X-axis on your LX2 does not move or moves irregularly during operation, you may be unable to complete your project. If you are experiencing this issue, this article may help you troubleshoot it.

Possible Cause 1: Loose or Broken X-Axis Belt

• Turn off the LX2.
• Check the X-axis motor belt for signs of looseness, breakage, or other damage.
• If the belt is broken, contact LaserPecker Technical Support for further assistance.

Possible Cause 2: Disconnected or Damaged X-Axis Motor Cable

• Turn off the LX2.
• Check the connection cable between the X-axis motor and the control board for any signs of a loose connection or damage.
• If the connection is loose, reconnect the cable. Restart the computer to check whether the issue has been resolved.

Possible Cause 3: Physical Damage to the Cable or Connector

• Turn off the LX2.
• Check the X-axis motor cable for breaks or other damage. If it is damaged, replace the X-axis motor cable.
• Check the pins inside the connectors on both the mainboard and the motor for bending or damage. If any pins are bent or damaged, replace the mainboard or the motor.

Possible Cause 4: Interference from Other Cables

• Turn off the LX2.
• Disconnect the Air Assist cable and check it for breaks or other damage. If it is damaged, replace the Air Assist cable.
• Leave the Air Assist cable disconnected and restart the device to prevent cable interference from causing irregular X-axis movement.

Possible Cause 5: Damaged X-Axis Limit Switch

• Check the X-axis limit switch for physical damage. To verify that it is functioning properly, manually trigger the limit switch and observe whether the X-axis motor stops immediately.
• Note: We recommend manually moving the X-axis to the far end of its travel first. Then wait for it to move automatically to the middle of its travel range before performing the trigger test. This helps prevent the moving assembly from colliding with the machine.

If the machine still does not operate properly or any cables are visibly damaged, contact LaserPecker Technical Support for further assistance. Please provide a detailed description of the issue and the troubleshooting steps you have already tried.