Assembling the Conveyor Feeder

1. Conveyor Feeder Base Kit Overview

2. Install the Conveyor Feeder

1. Before installing the Conveyor Feeder, install the Riser Base first. Open the front and rear doors of the Riser Base，Move the base plate to the lowest level of the Riser Base.(The Riser Base is sold separately.)

2. Move the base plate to the lowest level of the Riser Base.

   

3. Insert the Conveyor Feeder through the front door of the Riser Base.

   

4. Align the Main Unit Mounting Brackets on both sides of tthe Conveyor Feeder with the indicated level of the Riser Base and place them in position.

5. Align the Main Unit Mounting Brackets with the mounting holes on the Riser Base. Insert two M3*6 Hex Socket Screws on each side and tighten them with the H2.5 Hex Key.

   

6. Slide the T-nut in the inner slot to the A end of the EExtension Rod.

   

7. Align the holes on the Extension Rod Base with the T-Inut on the Extension Rod and tighten with an M6*6 Thumb Screw.(Repeat the same procedure for all four Extension Rods.)

   

8. Select any two Extension Rods. As shown in the illustration, connect the B End of the Extension Rod to the A End of the Connecting Rod.

   

9. Tighten with an M4*6 Thumb Screw.

   

10. Align the Extension Rod with the slots on both sides of the main unit and insert it.Slide it inward along the slots to the appropriate position.

    

11. Tighten using an M4*6 wing screw at the appropriate position.

    

12. Repeat Steps 10–12 to install the Extension Rod on the other side of the Conveyor Feeder.Make sure the distance between the Extension Rods on both sides is consistent and that they remain parallel to the edges of the machine.

    

13. Connect the power cable. (Turn off the LX2 before connecting the Conveyor Feeder to avoid damaging the machine.)

    

14. To prevent the cables from interfering with the back-and-forth movement of the workpiece during engraving, attach the Hook-and-Loop Strap to a suitable position on the back of the machine and organize the cables neatly.