LP3 Blinking Red and Green

Here is the troubleshooting guide for the LaserPecker LP3 blinking red and green light.

1. Preparation

LP3 Laser Unit, rubber suction cup*1, thin insulate rubber tape (1mm) *1/scotch tape *1, H3 wrench*1, ruler*1, thin knife*1/ tweezers*1

Preparation

(1) Use a thin knife or tweezers to peel off the black patch on the handle. (Please be careful when using the knife.)

step 1-1 step 1-2

(2) Unscrew the screw inside the handle using an H3 wrench.

step 2-1 step 2-2 step 2-3

(3) Use the suction cup to lift the Laser Unit cover plate, then use a ruler to fully open it. (Do not force it open, as this may deform the plate.)

step 3-1 step 3-2 step 3-3

(4) Cut two washers from the thin rubber insulating tape or tape, then glue them to the back of the two touch buttons.

step 4-1 step 4-2

(5) Reassemble the cover plate, handle, and black patch as originally installed. You have now completed all the necessary steps.

step 5-1 step 5-2

Related to