How to Set up LightBurn to Use the Slide Extension

  • Updated

How to do it

1. Connect LaserPecker LP4 to Lightburn

 2. Setting up for LP4

  • After connecting the machine, click the M command - M3031-slide to switch to slide mode.

1.png

  • Set the size of the working area. The working area needs to be reconfigured in slide mode, open [Edit]--[Device Settings] and set the width and height to 160mm and 300mm.

3.gif

Note: To switch to Normal Mode, use the M command - M3030-Normal Mode. After the switch, reset the working area to 160mm by 120mm.

 

 3. Processing for Slide Mode

Now that you have finished setting up LP4 with the Slide Mode, you can import a file or draw an engraving pattern, and start working with the Extension Slide by clicking the "Start" button on the right panel of LightBurn.

Was this article helpful?

0 out of 0 found this helpful