FAQs for LP1 Pro

  • Updated

Below, we've gathered a list of frequently asked questions about the LP1 Pro

  • Sorry, LP1 Pro isn't compatible with Lightburn currently.

  • LP1 Pro is a 0.5w, 405nm blue laser engraving machine.

  • LP1 Pro's focal length is from 190 mm to 200 mm.

  • LP1 Pro's max working area is 100 mm x 100 mm.

  • LP1 Pro can engrave at speeds from 1mm/s to 20mm/s.

  • The LP1 Pro can engrave on soft non-metal materials such as: - Paper
    - Leather
    - Wood
    - Bamboo
    - Plastic
    - Acrylic
    - Fruit
    - Felt
    - Cloth
    - Photosensitive stamps

  • When using the tripod, the LP1 Pro requires manual adjustment to set the correct focal length. However, with an auto-focus stand, it can automatically adjust to the correct focal length.

  • LaserPecker App (Community Version)

  • The LP1 Pro can operate continuously for up to 18 hours.

  • Accessories like LP1 tripod, LP1 auto-focusing stand, LP1 protective shield, magnet protective shields, LaserPecker power bank, can all be used with the LP1 Pro.

  • The LP1 Pro is registered with the following safety certifications; IEC60825-1, CE, FCC, FDA, CDRH. Click here for more information about laser safety certifications.

  • Please refer to our warranty policy for more details.

Was this article helpful?

17 out of 35 found this helpful

Do you have any problems or suggestions about this article?

Share feedback Open in a new tab

Comments

0 comments

Please sign in to leave a comment.